Why RangeXTD Login Page Isn’t Working On My Computer?

The RangeXTD extender has so many features (inbuilt) in the interface. But how will you enable when the login page isn’t working anymore. Here, you will find reasons and solutions to fix the RangeXTD login page isn’t working problem.

Reasons: Login Page Isn’t Working

The hardware damage troubles you with mentioned problem.

1. Out-dated firmware version can be a reason why your extender not working.
2. WiFi extender disconnection with the home router also troubles you with the same issue.
3. Non-optimal location in your house close to the electronic devices can cause you internet and network connectivity interruption.
4. If you have never configured the extender settings according to your area, then yes, you can face this similar problem.
5. Out-dated web browser can troubles you with the extender RangeXTD login not working problem.

Solutions:

Connect Extender to Router Securely

The extender connects with the router via WPS (Wi-Fi protected setup) method. Make sure that the extender is connected near to the router or within the reach of the main router. But if your routers don’t have any WPS support button, then you can use the Ethernet cable. Make sure the cable is not damaged from anywhere, if it is then replace it is the better option.

Change Extender Location

The optimal location should be selected for the Extender and any networking devices in your house. The reasons behind it are electromagnetic waves coming from the electronic devices. These waves interrupt the WiFi and internet signals, which cause low connectivity and Extender not working issues. So, change the location may solve your problem.

Check for Any Damage

The hardware and size of a range extender device is pretty small. So, if there is any damage on the surface or inside the hardware, you can’t see it. To check, you must see carefully. Ensure, port, buttons, antennas, the wall socket that you have used to supply power to the extender. If any damage found then, call a technician and make it right.

Configure Settings Again

You should configure the settings of the extender again from your computer or phone. For computer, use the IP address 192.168.7.234. Make sure, you have type the login Admin credentials (username and password).

Try Reboot/Restart

To reboot the device, you can use the power button on the extender, by pressing it twice the device will restart. There is one more way to restart the device. Just plug out the power adapter and plug it in again to restart the device.

Try Factory Reset

Reset by pressing the RESET button and hold it for 10 seconds. After releasing the button, the extender reset process will start. In few seconds, all settings and data will be deleted. Then you should configure the device via interface.

Troubleshooting Tips

Change Your Extender Password

Open the web browser and access the interface using the IP address like 192.168.7.234. Go to the Settings > Wireless Networks > Select SSID > enter the new username and password. Then, you must SAVE the settings.

Change Admin Window Password

Open the web browser and access the interface using the admin default username and password. Go to the Settings > Admin Settings > Select username or password field to change > enter the new username and password. Then you must SAVE the settings.

Change Frequency of Extender

Access the device interface in your computer with the help of the IP address. Go to the Settings > Wireless Networks > the choose Frequency bands > Choose channel based on the location of the house. Then SAVE the changes to apply.

End of Page

At the end of the post, you have learned about how to solve the RangeXTD extender not working issue within few minutes.